How to charge an AdMos sensor

AdMos_rendering

Charge the sensors

To charge the AsMos sensor, you can use the USB cable if you need to charge only one sensor at the time. Or you can charge multiple sensors at the same time using a docking station.

Below we will explain how to charge one sensor with the USB cable.
To know how to charge multiple sensors at the same time with a docking station, please read section How to Sync and charge AdMos sensors with a the docking station.

  • Plug your device to your computer or to an USB power supplier using the USB cable provided with the device.
  • Once your device is connected, the LED light will start blinking in blue.  LED light blinking Blue
  • Once the sensor is fully charged, the LED will stop blinking and become steady blue.  LED light Blue
  • You can now unplug the sensor.

Note: we recommend to charge the device some hours before using it. Do not leave it charging all the time.
If the device was not used for some months, a full charge could take longueur than usual. In this case, set it on charge 24h before using it again.

上部へスクロール