Inspirit

Sensor details To get your device details, you need to follow the below steps: Plug your device to your computer using the USB cable provided with the device. Once your device is recognised by your computer, the below message will appear at the bottom right of your screen.By clicking on the message, Insiders website will

LED lights table The below table explain in detail the meaning of both LED lights colours and status. LED light colour Blinking speed Device status Slow Synchronising with GPS signal and measuring heart rate with the WizShirt Fast Synchronised and ready to use with the WizShirt Slow The sensor is charging Steady ON The sensor

Note: this procedure works with version 3.9 and higher. If it is not the case yet, please update it with this procedure: docking update. This will erase the docking’s content so be sure to contact support before performing the procedure. Power down the docking station. Make sure there is no sensor connected. Download the .txt

Warning: this procedure only applies to dockings badged with “Insiders”. Note: this procedure will update your docking to the version 3.12. No Update available yet. Warning: prior to update the docking, ensure you have retrieve the backup data. The update process erases all data present in the docking. Download the “docking.zip” from this link: Docking

Download data from the sensors To download the data from the device, you can do it sensor by sensor or with the Hub or with a docking. Important note : To know how to download data directly from your devices to your favorite Data Scientists management platform, please contact directly the support of your Data

Sensor configuration To configure your device, you need to follow the below steps: Plug your device to your computer using the USB cable provided with the device. Once your device is recognised by your computer, the below message will appear at the bottom right of your screen.By clicking on the message, Insiders website will be opened

Update with the Updater tool Warning: prior to update a device, ensure you have retrieve all data. The update process erases all data present in the device. If you do not have a docking station or if you would like to update a single sensor at the time, the update can be launched manually using

Update the Sensors Warning: prior to update a device, ensure you have retrieve all data. The update process erases all data present in the device. Download the “app.zip” from this link: sensors firmware. Copy it on the provided USB key without unzipping the file. Make sure the file is named “app.zip“!!! /! Remove brackets and

Data Synchronization Note : Once the synchronization is done, data are automatically deleted from the sensors. So be sure you have saved the data on the provide USB Key as mentioned below. Connect all your sensors to the docking station before powering it up. Power up the docking station. Wait until the docking boots up